● Make sure the GPS receiver has a lock on the satellites.
● Check the location configuration for the sites and channel groups in the system.
1. For each site or channel group, go to the Set LocationInfo menu.
2. Check the range, latitude, and longitude settings to make sure they are correct.
3. Make sure the Set GPS Enable option is set to Yes .
This page applies to the following scanner(s): BCD396XT BC346XT Users
Guide
file:///C|/Documents%20and%20Settings/POpitz/My%20D...p/CDImage_090515/Manual/ConnectingAGPSReceiver.html (3 of 3)5/26/2009 11:13:52 AM
To Next Page
Loading...
