Tone Out mode
This page applies only to the BCD396XT and BC346XT. For other models
see:
● BCD996XT Tone Out Mode
● BCT15X Tone Out Mode
With the tone out feature, the scanner monitors up to 10 different channels for paging tones
(two-tone sequential, single tone, and group tone). Normally, the scanner monitors each of
the 10 channels in turn. However, if any tone-out channels share the same frequency,
modulator, and attenuator settings, the scanner checks these channels simultaneously.
Configuring Tone Out channels
To configure Tone-Out channels:
1. Go to the Tone-Out for... menu.
2. Select Tone-Out Setup .
3. Select the Tone-Out channel ( Tone-Out 1 through Tone-Out 10 ) you want to
configure.
4. Select Set Frequencies and choose the frequencies for this channel
5. Select Set Tone and program Tone A and Tone B.
6. Set any of the other properties as you prefer (they aren't required).
Required Frequencies ( Set Frequencies)
Tone A and Tone B ( Set Tones)
Recommended Name ( Edit Name)
file:///C|/Documents%20and%20Settings/POpitz/My%20Documents/temp/CDImage_090515/Manual/ToneOutMode.html (1 of 4)5/26/2009 11:13:54 AM
To Next Page
Loading...
