Set Frequencies
To determine whether the information on this page applies to your
scanner, see the tags at the bottom of the page.
This menu lets you create frequencies and edit existing ones. All existing frequencies are
listed in the order they were created: select the frequency you want to edit, or select New
Frequency to create a new one. When creating frequencies, keep the following rules in
mind:
● You can't duplicate frequencies within a site.
● You can store at least 500 frequencies per site.
● You can store up to 1000 frequencies per site, depending on the number of TGID
in the entire system.
● Set Frequencies
❍ Edit Frequency
❍ Set Lockout
❍ Delete Frequency
❍ New Frequency
● LTR and EDACS system options
❍ LCN (Logical Channel Number)
● EDACS SCAT system options
❍ Set Number Tag
❍ Volume Offset
❍ Set Record (BCD996XT and BCT15X Only)
Edit Frequency
Enter a valid frequency for this band. If the frequency is invalid or if it already exists, the
scanner sounds an error tone and prompts you to re-enter the frequency.
Set Lockout
Determines whether the frequency will be scanned. If you lock out the frequency and the
frequency is used as the control channel, the system will not be scanned.
file:///C|/Documents%20and%20Settings/POpitz/My%20Documents/temp/CDImage_090515/Manual/SetFrequencies.html (1 of 3)5/26/2009 11:14:49 AM
To Next Page
Loading...
