Uniden BCD396XT User Manual

EditSysOption < UnidenMan4 < TWiki
Set State (BCT15X Only)
Sets the U.S. State or Canadian Province associated with the system. If selected, the
system will be unlocked when you set the scanner to the state and locked out when you
select a different state.
Conventional system options
The following options are available when you're editing a conventional system:
Set Quick Key
Assign this system or site to a Quick Key so you can easily enable or disable it during
scanning. Enter a number from 0 to 99; tap NO (the decimal point) if you don't want to
assign this system or site to a Quick Key. (For more information, see Quick Keys.)
Set Startup Key
Assign this system or site to a Startup Key so you can lock or unlock it during power up.
Enter a number from 0 to 9; tap NO (the decimal point) if you don't want to assign this
system or site to a Startup Key. (For more information, see Startup Keys.)
Set Lockout
Decide whether you want to lock out the system so the scanner will ignore it during Scan
and Search modes. If you lock out a system, all channels within that system are locked
out. Choose one of the following options:
● Unlocked: The system is not locked out.
● Temporary L/O: The system is locked out until you turn the scanner off and back
on.
● Lockout: The system is permanently locked out.
Set Hold Time
Set the minimum number of seconds the scanner should spend checking this system or
site even if there is no traffic on any channel. (The scanner always checks each channel
file:///C|/Documents%20and%20Settings/POpitz/My%20Documents/temp/CDImage_090515/Manual/EditSysOption.html (3 of 7)5/26/2009 11:14:43 AM

Uniden BCD396XT Specifications

General

Belt clip	Yes

Weight and Dimensions

Weight	907 g
Dimensions (WxDxH)	51 x 25 x 1152 mm