● Extend : The scanner will output the control channel data along with any
description.
Set GPS Format
Configure how the scanner displays position coordinates, time, and units during GPS
operation:
Set Pos Format
Select how the scanner displays longitude and latitude:
● DMS: DDD° MM' SS.ss : Display coordinates in degrees (DDD), minutes (MM),
and seconds (SS.ss).
● DEG: DDD.dddddd : Display coordinates as decimal degrees.
Set Time Format
Select 12H for 12-hour (am/pm) time format or 24H for 24-hour time format.
Set Time Zone
Set the number of hours your local time zone differs from universal time (GMT/UTC).
Select from -14 hours to +14 hours in half-hour (0.5 h) increments.
Set Unit
Select the unit used for distance: mile or kilometer (km).
Set Serial Port
Select the port you are adjusting ( Set Front Port or Set Rear Port) Then, set the baud
rate for the selected serial port. Choose from 4800, 9600, 19200, 38400, 57600 , or
115200 bps; select Off to disable the serial port.
The front port defaults to 115200 bps. The rear port defaults to 4800 bps to maintain
compatibility with GPS units.
file:///C|/Documents%20and%20Settings/POpitz/My%20D...ts/temp/CDImage_090515/Manual/BCD996XTSettings.html (4 of 6)5/26/2009 11:15:47 AM
To Next Page
Loading...
