Set Interval
Decide how many seconds you want the scanner to wait between priority channel
checks. Enter a number between 1 and 10 seconds. (This setting is used in normal
priority scans only.)
MaxCHs/Pri-Scan
Decide how many priority channels the scanner checks during each interval. Enter a
number between 1 and 100. If the number of priority channels is greater than the number
you enter here, the scanner divides them into groups. For example, if you set the
maximum channels to 20 and there are 100 priority channels, the scanner checks those
100 channels in groups of 20 and takes a total of 5 intervals to complete the priority
scan.
This page applies to the following scanner(s): BCD996XT BCT15X BCD396XT
BC346XT Users Guide
file:///C|/Documents%20and%20Settings/POpitz/My%20Documents/temp/CDImage_090515/Manual/PriorityScan.html (2 of 2)5/26/2009 11:15:53 AM
To Next Page
Loading...
