Uniden BCD396XT User Manual

PriorityScan < UnidenMan4 < TWiki
Priority Scan
To determine whether the information on this page applies to your
scanner, see the tags at the bottom of the page.
This section applies to conventional system priority mode only. For priority on trunked
systems, turn on the Priority ID system option and set the desired channels as priority
channels.
Priority mode has two "sub modes" (similar to Close Call and Close Call Only):
● In Priority Scan mode, the scanner pauses the current operation at a designated
interval to check for activity on any unlocked channels set as priority channels.
After the priority channel check is complete, the scanner resumes the previous
operation.
● In Priority Plus Scan mode, the scanner stops the current operation and only
checks the priority channels.
● Priority Scan menu
❍ Set Priority
❍ Set Interval
❍ MaxCHs/Pri-Scan
Priority Scan menu
Use the Priority Scan menu to control how Priority mode operates:
Set Priority
Choose one of the following priority scan methods:
● On : Enter Priority Scan mode; also, the scanner performs a normal priority scan
whenever you enter Priority mode in the future.
● Plus On : Enter Priority Plus Scan mode; also, the scanner performs a priority
plus scan whenever you enter Priority mode in the future.
● Off : Exit Priority mode, and do not go into Priority mode in the future.
file:///C|/Documents%20and%20Settings/POpitz/My%20Documents/temp/CDImage_090515/Manual/PriorityScan.html (1 of 2)5/26/2009 11:15:53 AM

Uniden BCD396XT Specifications

General

Belt clip	Yes

Weight and Dimensions

Weight	907 g
Dimensions (WxDxH)	51 x 25 x 1152 mm