move the cursor to the next character.
Edit Srch Limit
Change the range of frequencies covered by this custom search. The scanner prompts
you to input the lower frequency limit and then the upper frequency limit.
Set Delay Time
Set the number of seconds the scanner should wait after a transmission stops before
moving on to the next channel. Select 0, 1, 2 (default), 5, 10, or 30 seconds.
To have scanner leave the channel after a designated number of seconds whether the
transmission stops or not, select one of the negative values. Choose -10 seconds to have
the scanner leave the channel after 10 seconds even if the transmission is still going on;
choose -5 seconds or -2 seconds to have the scanner leave after 5 seconds or 2 seconds,
respectively.
Set Modulation
Select what type of modulation the scanner should use for this frequency or channel.
(Only the modulation types available for this frequency or channel are displayed.)
Auto The scanner uses the default modulation type for this frequency's
band.
AM The scanner treats the frequency as an AM band.
NFM The scanner treats the frequency as a Narrowband FM band.
FM The scanner treats the frequency as an FM band.
WFM The scanner treats the frequency as a Wideband FM band.
FMB The scanner treats the frequency as an FM broadcast band.
Set Attenuator
Turn on attenuation to reduce the signal strength by 20 dB. All frequencies in the search
range are attenuated during search.
Set Step
file:///C|/Documents%20and%20Settings/POpitz/My%20Documents/temp/CDImage_090515/Manual/SearchFor.html (4 of 6)5/26/2009 11:16:00 AM
To Next Page
Loading...
