ViaSat ArcLight - Figure 5-30. MCD Mcc_Build Commands; Figure 5-31. MCD Atm_Len_Bin_Show Command

ArcLight Hub User’s Guide
Component Operating Procedures
Rev. 001 1081006 5-47
5.10.7.3.5 MCD ‘mcc_build’ Commands
Figure 5-30 shows the two available M&C build information commands:
• ‘mcc_build_all_info_show’ – displays information about currently
running M&C application software (same as obtained through
‘fw’ command.
• ‘mcc_build_all_boot_info_show’ - displays Information about the
M&C boot software build that was used to load and start the
currently running M&C application software.
Figure 5-30. MCD ‘mcc_build’ Commands
5.10.7.3.6 MCD ‘atm_len_bin_show’ command
Figure 5-31 shows a typical response for the ‘atm_len_bin_show’
command which displays how many IP packets have been reassembled
by the M&C. The length of the IP packets is in the range indicated in
parenthesis, i.e. (0-99) 165500 indicates 165,500 packets reassembled
have a length between 0 and 99 bytes. The “Err=” displays how many
packets were not able to be reassembled correctly.
Figure 5-31. MCD 'atm_len_bin_show' Command
5.10.7.3.7 MCD ‘err_print’ Command
Figure 5-32 shows a typical response to the ‘err_print’ command. Table
5-9 lists and describes the fields in this command.
-> mcc_build_all_info_show
Build ID: vxWorks.bin.Z - Version: 2.3.10 - Created on: Aug 11 2006, 17:09:29
value = 78 = 0x4e = 'N'
-> mcc_build_all_boot_info_show
Build ID: bootrom.bin - Version: 2.3.0 - Created on: Jan 19 2006, 14:03:23
value = 75 = 0x4b = 'K'
->
-> atm_len_bin_show
0x4d9aa00 (tShellRem1): (0-99)288039 (100-199)0 (200-499)220 (500-999)0
(1000-1499)1 Err=0
value = 71 = 0x47 = 'G'
->