Wacker Neuson EZ38 - Differential Lock; Lights;Signalling System; Working Lights

5-8 OM EZ38 us 1.1 * ez38b500.fm
5
5.5 Differential lock
Not available.
5.6 Lights/signalling system
Working lights
The switch is located on the left-hand control lever base.
WARNING
Accident hazard! Motorists can be blinded by bright lights on the job
site.
Can cause serious injuries or death.
► Switch on the working lights only if motorists are not expected to be
blinded.
► Stop machine operation if motorists are blinded.
► Only take up work again if sufficient illumination of the job site can be
ensured without blinding other motorists.
Information
Switch on the working lights in poor light conditions. If illumination still is
not sufficient, use external lights. If this is yet not enough to illuminate the
job site sufficiently, stop work and only take it up again if sufficient
illumination can be ensured.
Fig. 127
40
Position Function
ON Press switch 40 down
Working lights switched on, the
indicator light in switch 40 illu-
minates
OFF Press switch 40 up
Working lights switched off, the
indicator light in switch 40 goes
out
Fig. 128
A
B
Position Designation
A Working light (standard)
B Front and rear working lights (option)