EasyManua.ls Logo

Wacker Neuson EZ38 - Fuses and Relays; Battery Charge Condition; Charging the Battery; Replacing the Battery

Wacker Neuson EZ38
254 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
7-48 OM EZ38 us 1.1 * ez38w710.fm
7
Fuses and relays
Blown fuses indicate overloading or short circuits. Have the electrical
system checked by a Wacker Neuson service center.
Only use fuses with the specified amperage.
see chapter “ Relays” on page 9-5
see chapter “ Fuses” on page 9-4
Battery charge condition
May only be checked by a Wacker Neuson service center.
Charging the battery
May only be performed by a Wacker Neuson service center.
Replacing the battery
Tilt the cabin to access the battery.
see chapter “ Raising or lowering the cabin” on page 7-15
The battery is “maintenance-free”. However have the battery checked at
regular intervals to ensure that the electrolyte level is between the MIN
and MAX marks.
Checking the battery requires it to be removed and must be performed by
a Wacker Neuson service center.
Always follow the specific battery safety instructions.
NOTICE
In order to avoid damage to the engine electronics, do not disconnect the
battery while the engine is running.
Fig. 265
+
-

Table of Contents