9-20 OM EZ38 us 1.1 * ez38t900.fm
9
Safety instructions – stability table
The values of the stability table (load diagram) apply to lifting gear
applications.
Crushing hazard due to tipping over of machine!
Will cause severe injuries or death.
► Never exceed the weight and mass values specified in the stability
table.
► If a joint rod or Powertilt unit with load hook is installed, the weight of
the attachment must be subtracted from the weight or mass value
specified in the table.
► Use the machine for lifting gear applications only if the mandatory
lifting gear (joint rod, for example) and safety equipment (optical and
acoustic warning devices (safe load indicator), stability table, load
holding control valves, for example) is installed, functional and
enabled.
If the weight or mass value is exceeded, there is a risk of damage to
property if the machine tips over.
► Never exceed the weight and mass values specified in the stability
table.
The indications are only approximate values. Attachments, uneven
ground and soft or bad ground conditions affect stability, and the weight
and mass values. The operator must take these influences into account.
To Next Page
Loading...
