4-26 OM EZ38 us 1.1 * ez38i400.fm
4
Protective Front Guard structure level I (option)
Crushing hazard by objects from the front!
Will cause severe injury or death.
► Install a protective Front Guard structure in areas with hazard from the
front, for example pipes, tree trunks etc.
► Machine operation is prohibited without a protective Front Guard
structure.
The protective Front Guard structure corresponds to level I according to
ISO 10262:1998.
► The machine owner must ensure that the hazard situation is evaluated
and that the national regulations are observed.
► The machine owner must ensure that only work is performed that does
not require any higher protection.
► Accidents cannot be fully avoided despite equipping a machine with
protective structures.
Installing
1. Stop and park the machine. Stop the engine. See “Preparing
lubrication”.
2. Remove all lights and mirrors (option).
3. A minimum 2 persons are required for installing/removing.
4. Install the lock nuts and screws on either side.
5. Mounting point for protective structure: A (upper).
To Next Page
Loading...
