5-22 OM EZ38 us 1.1 * ez38b510.fm
5
Hammer operation (option)
Information regarding hammer operation
Use the canopy version only with a shatter protection during hammer
operation.
If the machine is equipped with a cabin (option), the front window must be
closed.
– see chapter “ Shatter protection (option)” on page 4-28
Piercing/penetration hazard by objects from the front!
Work involving piercing/penetrating objects from the front can cause
accidents with serious injuries or death.
► During operation, all persons must stay clear of the work area of the
machine.
► Do not place the machine directly underneath the workplace during
demolition, otherwise debris can fall onto the machine or the building
can collapse.
► Only work on the job site.
► Operate the canopy version only with a shatter protection. If the
machine is equipped with a cabin (option), all windows and doors must
be closed.
Accident hazard due to tipping over of machine!
A tipping machine can cause serious injuries or death.
► During operation, all persons must stay clear of the work area of the
machine.
► Do not perform any demolition work under the machine. This could
cause the machine to tip over.
► The machine can lose its balance and tip over if a hammer or other
heavy attachment is used.
► Never turn, lower or set down the attachment abruptly.
► Do not extend or retract the boom abruptly.
► Do not use the impact force of the attachment to perform demolition
work. Broken or falling debris can cause serious injuries.
► Machine travel is prohibited during hammer operation.
If several sizes of hydraulic hammers are available for the machine, the
following applies when using the Powertilt unit:
► Always use the smallest possible hydraulic hammer.
► Contact your dealer for information on the correct equipment.
To Next Page
Loading...
