4-46 OM EZ38 us 1.1 * ez38i400.fm
4
Damage to battery jumper cables when placing them near rotating parts.
► Do not place the battery jumper cables near rotating parts.
Use only authorized battery jumper cables which conform to the safety
requirements.
1. Travel the jump-starting vehicle close enough to the machine with the
discharged battery so that the length of the jump leads is sufficient.
2. Let the engine of the jump-starting vehicle run.
3. Open the engine cover of the machine with the discharged battery.
4. Remove the plastic cap at the rear of battery master switch A.
5. First connect one end of the red battery jumper cable (+) to the rear of
battery master switch A, then connect the other end to the positive
terminal of the starting battery.
6. Connect one end of the black battery jumper cable (−) to the negative
terminal of the starting battery.
7. Connect the other end of the black battery jumper cable (−) to metal
part B.
8. Wait at least 5 minutes for the discharged battery to be charged a little.
9. Start the engine of the machine with the discharged battery.
Once the engine has started:
With the engine running, disconnect both jump leads in exactly the
reverse order (first the negative terminal –, then the positive terminal +).
➥ This prevents sparking.
Fig. 111
Starting
battery
A
B
To Next Page
Loading...
