OPERATING AND OPERATION
103
WL50
Before assembly, start-up or maintenance, read the
1.
Operator’s Manual for the relevant attachment.
Practice using the attachment before working with it the
2.
rst time. Familiarize yourself ahead of time with all the
functions and control elements.
The loader is equipped with a hydraulic quick-change sys-
tem for various attachments. The operator can thus couple
and uncouple attachments in a quick and uncomplicated
manner, from the operator‘s seat.
When loading, adjust your driving speed to the •
material being loaded and traction conditions.
Avoid contact with hydraulic uid in the event of
•
pressurized leakage. In the event high pressure
uid comes in contact with skin, or if hydraulic
uid enters the eye, seek immediate treatment
in an emergency room.
Do not use an attachment unless it is in service-
•
able condition.
Before attempting to uncouple an attachment, •
read the instructions for the uncoupling process.
Conrm that the attachment will not move when
removed from the loader lift arms.
To avoid personal hazards and potential ma-
•
chine damage, conrm that the attachment is
properly and rmly connected to the loader lift
arms before use.
Do not perform service or repairs on the attach-
•
ment unless the loader and loader lift arms are
secured as described in section 9 page 137
»Securing the Loader«.
NOTICE
Unapproved attachments could overload the loader.
This can result in damage to the loader.
To Next Page
Loading...
