SERVICING AND INSPECTION
192
Changing the hydraulic uid
WARNING
Burn hazard.
The operating temperature of the hydraulic sys-
tem is 93°C (200°F). Contact with skin will cause
severe burns.
Wear protective clothing. ►
Rinse affected areas with water immediately
►
and seek medical treatment.
eNVIRONmeNTAl NOTe
Avoid environmental damage.
Collect old hydraulic uid and dispose of it in an
ecologically sound manner.
Refer to Section 10.6, page 163 »Specications
and lling quantities« to determine the necessary
container volume to avoid spillage.
Adding hydraulic uid
If the uid level is under the »Maximum« mark, add hydraulic
uid until the maximum level is reached.
Open the hydraulic uid ller neck cap Item 1 (Fig.
1.
90).
Add hydraulic uid.2.
Check the hydraulic uid level.3.
Add hydraulic uid until the uid level is at the »Maxi-
4.
mum« mark.
Close the hydraulic oil ller neck cap Item 1 (Fig. 90).5.
Use the correct oil grade (reference Section 10.6,
page 163 »Specications and lling quantities«).
Open the hydraulic oil ller neck cap Item 1 (Fig.
90) carefully so that the pressure can escape from
the reservoir.
To Next Page
Loading...
