SERVICING AND INSPECTION
207
WL50
Stop the loader on a horizontal surface with a hard foun-
1.
dation and set the parking brake.
Lower the Loader lift arms and attachment to the ground
2.
or work surface.
Stop the engine.3.
Position the jack under the axle next to the wheel to
4.
be changed. Make sure that the loader cannot slip off
the jack.
Loosen the wheel bolts.5.
Raise the jack just high enough so that the wheel does 6.
not touch the ground.
Remove the wheel bolts and the wheel.7.
Install the new wheel and the wheel bolts.8.
Tighten the wheel bolts.9.
Lower the jack.10.
Alternately tighten the wheel bolts opposite each other 11.
to the specied tightening torque.
To Next Page
Loading...
