6 Notes about this Documentation WAGO I/O System 750 XTR
750-677/040-000 4PWM 24 VDC 0.2A XTR
Manual
Version 1.0.0
1 Notes about this Documentation
Always retain this documentation!
This documentation is part of the product. Therefore, retain the documentation
during the entire service life of the product. Pass on the documentation to any
subsequent user. In addition, ensure that any supplement to this documentation
is included, if necessary.
1.1 Validity of this Documentation
This documentation is only applicable to the I/O module 750-677/040-000
(4PWM 24 VDC 0.2A XTR).
The I/O module 750-677/040-000 shall only be installed and operated according
to the instructions in this manual, in the system description for the WAGO I/O
System 750 XTR and in the manual for the used fieldbus coupler/controller.
Consider power layout of the WAGO I/O System 750 XTR!
In addition to these operating instructions, you will also need the system
description “Design Notes XTR – Guidelines and Recommendations for
Increasing Operational Safety” and the manual for the used fieldbus
coupler/controller, which can be downloaded at www.wago.com
. There, you can
obtain important information including information on electrical isolation, system
power and supply specifications.
1.2 Copyright
This Manual, including all figures and illustrations, is copyright-protected. Any
further use of this Manual by third parties that violate pertinent copyright
provisions is prohibited. Reproduction, translation, electronic and phototechnical
filing/archiving (e.g., photocopying) as well as any amendments require the
written consent of WAGO GmbH & Co. KG, Minden, Germany. Non-observance
will involve the right to assert damage claims.
To Next Page
Loading...
Need help?
General
