Safety
12 / 112 28.03.2022
2.3 Safety sign
The parts of the device which represent a danger are marked with a
safety label.
Mandatory
Make sure that the safety labels on the device are clearly
legible and clean!
If the labels become dirty or illegible over time, so that hazards can no
longer be identified or service instructions can no longer be followed,
they must be replaced with new ones and affixed to the same place.
2.3.1 Labels on the device
The stickers listed below are affixed to the ProofMaster.
Calibration of the
ProofMaster
The sticker on the underside of the device shows when the device was
last calibrated.
Info
The reliability of the measurement results is guaranteed by
regular calibration of the ProofMaster.
Maximum supply pressure
This sticker is located next to the connection point of the compressed air
supply. The maximum supply pressure must not exceed 12bar.
2.3.2 Labels on the power supply unit
The labels below are affixed to the power supply unit.
Electrical and electronic
components
The electrical and electronic components in the device contain toxic
substances. The device must therefore be disposed of in a recycling
depot or by a specialised company.
CE conformity
The "CE" marking confirms that this product complies with the
European requirements regarding safety, health, environmental and
user protection.
2.4 Residual risks
Compressed air
The compressed air devices can be dangerous if they are disconnected
when compressed air is present. A pressurised line that is disconnected
can cause the air to escape extremely quickly as a result of the escaping
pressure, thus posing a danger, especially to the eyes and face.
To Next Page
Loading...
