wtw inoLab Multi 9620 IDS - Page 110

Settings inoLab
®
Multi 9620 IDS
110 ba77173e04 12/2017
Conductivity The following settings for conductivity measurements are reset to the default
settings with the Reset function:
The sensor settings are reset under the Reset menu item in the menu for cali-
bration and measurement settings. To open the settings, display the required
measured parameter in the measured value display and press the <ENTER>
key.
Setting Default settings
Calibration interval 150 d
Measured parameter ϰ
Cell constant (c) Depending on the connected measur-
ing cell:
0.475 cm
-1
(calibrated)
0.475 cm
-1
(set)
0.100 cm
-1
Temperature compensation nLF
Reference temperature 25 °C
Temperature coefficient (TC) of
the linear temperature compensa-
tion
2.000 %/K
TDS multiplier 1.00