08/2012
6-11
WorkCentre 5021/5019
6.1.11
General Procedures
Initial Issue
6.1.11 Environmental Friendliness
6.1.11.1 Energy Star Program, Blue Angel Mark and ErP Lot6
The table below shows the time to enter other mode after operation completion and power con-
sumption in each mode.
• *1: Actual measured power value, which is base of the power value notified to Energy Star
Program.
• *2: Factory default setting.
• *3: Used for Blue Angel Mark acquisition. (Not applicable for this product)
• *4: Used for ErP Lot6 (EMC Class B product for EU) certification. (Not applicable for this
product)
• *5: Measured by Energy Star tesing condition.
Table 1 (Input voltage: AC115V/AC230Vz)
Configuration TEC method Low Power Mode
Power (Standard)
(kWh/week)
(Reference) Power (BA Std)
(W)
Power (Catalog)
(W)
Power(W)*1 *3 Shift time *2 *3 Recovery time (for BA)
*3
18PPM CPS Platen/Simp (230V) 2.3 1.232 - 50 42 1min -
20PPM CPS DADF/Dup (230V) 2.5 1.343 - 50 42 1min -
18PPM CPS Platen/Simp (115V) 2.3 1.233 - 45 40 1min -
20PPM CPS DADF/Dup (115V) 2.5 1.370 - 45 40 1min -
Table 2 (Input voltage: AC115V/AC230Vz)
Configuration Sleep Mode
Power (BA Std) (W) Power (Catalog)
(W)
Power(W)*1 *3 Shift time *2 *3 Recovery time
(for BA)*3
Recovery time
(Catalog)*5
18PPM CPS Platen/Simp (230V) - 3.0 2.5 1min - 30sec
20PPM CPS DADF/Dup (230V) - 3.0 2.6 1min - 30sec
18PPM CPSPlaten/Simp (115V) - 3.0 2.4 1min - 30sec
20PPM CPSDADF/Dup (115V) - 3.0 2.5 1min - 30sec
Table 3 (Input voltage: AC115V/AC230Vz)
Configuration Ready Mode Plug-in Off Mode *4
Power (BA Std) (W) Power (Catalog)
(W)
Power (W)*1 *3 Power (ErP Std)
(W)
Power (W)*3
18PPM CPS Platen/Simp (230V) - 65 56 - -
20PPM CPS DADF/Dup (230V) - 65 60 - -
18PPM CPS Platen/Simp (115V) - 75 65 - -
20PPM CPSDADF/Dup (115V) - 75 67 - -
To Next Page
Loading...
Need help?
General
