08/2012
6-44
WorkCentre 5021/5019
6.3.6
Initial Issue
General Procedures
710-608 Alternate Size Set 8 0-4 0 O Switches among B4 SEF, 8K SEF, and 11x17 SEF.
0: Default
1: B4S
2: 8K SEF
3: 11X17S
710-609 Alternate Size Set 9 0-2 0 O Switches between 8x10 SEF and 8x10.5 SEF.
0: Default
1: 8X10S
2: 8X10.5S
710-610 Alternate Size Set 10 0-3 0 O Switches among B5 LEF, 16K LEF, and 8.5x11 LEF.
0: Default
1: B5L
2: 16K LEF
3: 8.5X11L
710-611 Alternate Size Set 11 0-3 0 O Switches among B5 SEF, 16K SEF, and 8.5x11 SEF.
0: Default
1: B5S
2: 16K SEF
3: 8.5X11S
710-612 Size-Mix Mode Size Orientation 0-1 1 O Switches between LEF and SEF
0: LEF
1: SEF
710-613 Fax Job Mixed Size Standard Size
Mode
0-1 0 O During Fax Mixed Size Mode, switches the size (Standard/Non-standard) notified to IISS from the
DADF.
0: Non-standard mode
1: Standard mode
710-620 DADF DPM Setting 0-65535 0 O Specifies the DPM for DADF.
0: Operates at the maximum performance DPM of DADF
1~65535: Operates at the specified DPM (in increments of 1 DPM)
715-010 Energy Saver Mode Disabling NVM 0-1 0 O Setting Value: 0
At Power OFF: Move the CRG to the W-Ref board position. *Note
At Power ON: Initialize the CRG.
Returning from Energy Saver: Do not initialize the CRG.
Setting Value: 1
At Power OFF: Do not move the CRG.
At Power ON: Initialize the CRG.
Returning from Energy Saver: Initialize the CRG.
715-017 IIT Fail Bypass 0-1 0 O 0: Fail Bypass OFF
1: Fail Bypass ON
715-018 Config Fail Bypass 0-1 0 O Controls whether to perform Fail bypass for the [Configuration Check].
0: Fail Bypass OFF
1: Fail Bypass ON
715-022 Lamp Fan Fail Bypass 0-1 0 O Lamp Fan Fail Detection
0: Detects Lamp Fan Fail.
1: Does not detect Lamp Fan Fail.
Table 1 NVM IIT
Chain-Link NVM Name
Setting
Range
Default
Value Read/Write Description
To Next Page
Loading...
Need help?
General
