Xerox WorkCentre 5022 User Manual

Loading Paper
Xerox
®
WorkCentre
®
5022/5024 Multifunction Printer
User Guide
4-9
Changing Paper Size
This section describes how to change paper size in Trays 1 to 4.
Notes
• Do not load mixed paper sizes into a tray.
• A paper type is preset for Trays 1 to 4. Normally, Plain 1 is set for the trays. When changing it to a
different paper type, change the paper quality settings to match the type of paper to be loaded so
that you can maintain high quality printing. For more information on how to set the paper quality,
refer to Changing the Paper Settings on page 4-11.
Changing the Paper Size for Trays 1 to 4
1. Pull out the tray until it stops.
Notes
• While the machine is copying or printing, do not pull out the tray that the job uses.
• To prevent paper jams or loading errors, do not load different sizes or types of paper on top of any
remaining paper in a tray.
2. Remove any paper loaded in the tray.
3. For Tray 1, push down the metal plate to the bottom of the tray.

Xerox WorkCentre 5022 Specifications

General

Copy Resolution	Up to 600 x 600 dpi
Scan Resolution	Up to 600 x 600 dpi
Connectivity	USB 2.0
Functions	Print, Copy, Scan
Duplex Printing	Manual
Paper Sizes	A3, A4, A5, B4, B5
Memory (Standard)	128 MB
Print Technology	Laser
Print Speed	Up to 22 ppm
Print Resolution	600 x 600 dpi
Copy Speed	Up to 22 cpm
Operating System Compatibility	Windows, Mac
First Page Out Time (Copy)	8 seconds