Fax
Xerox
®
WorkCentre
®
5022/5024 Multifunction Printer
User Guide
6-21
Send Priority
Used to prioritize the transmission of a fax, to have it supersede any other faxes that may be pending.
Only one job can be selected for Send Priority.
Notes
• Faxes, including priority faxes, that fail due to transmission errors will not be resent. However, faxes
that fail during transmission or while the recipient's line is busy will be resent. In this case, if a
pending document comes up that is ready to be sent before resending of failed faxes begins, the
failed fax is resent after the pending document that is ready is sent.
• When a current or pending priority fax fails due to a transmission or similar error, you cannot set
another priority fax until all of the documents for which Send Priority was set have been sent.
• Priority faxes can't be fax broadcasts (faxes sent to multiple recipients at once).
1. Select Send Priority, and then press the OK button.
2. Select On, and then press the OK button.
Note Select Off to disable the priority fax setting.
Polling
Used to issue a command to a remote machine to send a stored document.
Notes
• Only one job can be selected for Polling.
• The Polling function may not be supported by some remote fax machines.
• The cost of the call will be charged to the machine.
• Only one recipient can be specified for single remote polling.
• It redials if the other party does not respond.
1. Select Polling, and then click the OK button.
Original Size
...
Auto
Lighten/Darken
...
Normal
Send Priority
...
Off
Ready to Fax: 0123457890
Send Priority
...
Off
Original Size
...
Auto
Polling
...
Off
Ready to Fax: 0123457890
To Next Page
Loading...
Need help?
General
