Too ls
Xerox
®
WorkCentre
®
5022/5024 Multifunction Printer
User Guide
9-38
Print Size (Received Letter)
Used to set the paper size to print document that was sent in Letter or A4 size.
Letter/A4 is set at the time of factory shipment.
The machine operates according to the Auto Reduce on Receipt or Border Limit settings on whether
to automatically reduce or discard portions of A4 document received when the paper size is set to
Letter/A4 or Letter.
Immediate Fax Switch
When the amount of remaining memory becomes low while saving an outgoing fax, the machine can
be set to start transmission during the save operation when the amount of remaining memory reaches
a set value. This is referred to as Immediate communication. Used to set the remaining memory level
to switch to the immediate communication.
You can set a value between 0 and 99% (in 1% increments).
0% is set at the time of factory shipment.
Off Hook Level
Used to set the level for detecting an off-the-hook receiver when an external phone is mounted.
You can select from 10 volts, 15 volts, 20 volts, 25 volts, and 35 volts. 10 volts is the lowest extraction
level, and 35 volts is the highest extraction level.
10 volts is set at the time of factory shipment.
Region
Sets the machine's region of use.
You can select from Unknown, India, Russia, South Africa, Central Africa, Emirates, Saudi Arabia,
Egypt, Mexico, or Turkey.
A4/B4 The machine restricts incoming faxes to A4 size (210 mm width) and B4 size (257 mm width).
A4/B4/A3 The machine restricts incoming faxes to A4 size (210 mm width), B4 size (257 mm width), and
A3 size (297 mm width).
Letter/A4 The machine prints the fax in Letter size first. If the Letter size is not available, it prints
in A4 size.
Letter The machine prints the fax in Letter size.
To Next Page
Loading...
Need help?
General
