EasyManuals Logo

Xerox WorkCentre 5022 User Manual

Xerox WorkCentre 5022
360 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #213 background imageLoading...
Page #213 background image
Too ls
Xerox
®
WorkCentre
®
5022/5024 Multifunction Printer
User Guide
9-27
Wired Network
Used to make network environment settings.
Note This function does not display unless the Network Kit is installed.
For information on how to display the Wired Network screen, refer to System Settings Procedure on
page 9-1.
Ethernet
Used to set the Ethernet type to use.
Speed
You can select Auto, 10BASE-T Half, 10BASE-T Full, 100BASE-TX Half, or 100BASE-TX Full.
Auto is set at the time of factory shipment.
MAC Address
You can select Auto, 10BASE-T Half, 10BASE-T Full, 100BASE-TX Half, or 100BASE-TX Full.
Auto is set at the time of factory shipment.
TCP/IP
Sets TCP/IP.
This setting is activated after restarting the machine.
IP Mode
Sets the TCP/IP operation mode.
IPv4 is set at the time of factory shipment.
Dual Stack Select this setting when using the machine in an environment using both IPv4 and
IPv6.
IPv4 Select this setting when using the machine in an IPv4 environment.
IPv6 Select this setting when using the machine in an IPv6 environment.

Table of Contents

Other manuals for Xerox WorkCentre 5022

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Xerox WorkCentre 5022 and is the answer not in the manual?

Xerox WorkCentre 5022 Specifications

General IconGeneral
Copy ResolutionUp to 600 x 600 dpi
Scan ResolutionUp to 600 x 600 dpi
ConnectivityUSB 2.0
FunctionsPrint, Copy, Scan
Duplex PrintingManual
Paper SizesA3, A4, A5, B4, B5
Memory (Standard)128 MB
Print TechnologyLaser
Print SpeedUp to 22 ppm
Print Resolution600 x 600 dpi
Copy SpeedUp to 22 cpm
Operating System CompatibilityWindows, Mac
First Page Out Time (Copy)8 seconds

Related product manuals