2. There are errors in the charging process,
including the vehicle power supply voltage
being too low or too high.
ZDUQLQJ
• The phone wireless charging function can
generate heat when in contact with metal.
Please make sure there are no metal objects
on the back of the phone or within the
charging area before initiating the charging
process. Failure to do so may result in the
metal objects being heated or damaged,
and in extreme cases, it could cause
safety incidents. Here, metal objects refer
to any other objects that contain metallic
components, including but not limited to
chips, magnetic cards, etc.
• Please avoid spilling water into the front
storage box, as this could cause water
getting into the wireless charging module
and damage the electronic components.
• The use of an external wireless charging coil
may lead to accidental incidents. Please use
with caution.
• When the driver is not in the vehicle, please
do not leave your phone charging inside the
car to avoid potential hazards.
• Please avoid placing heavy objects in the
charging area to prevent damage to the
wireless charging module.
• If the phone wireless charging function fails
or works abnormally, please stop using it
and contact the XPENG Service Center for
inspection and repair.
• It is no fault for the phone to heat up after
charging for a long time. After the charging
device is fully charged, please do not leave
it on the charging pad to avoid overheating.
• Please avoid using phone cases made
of metallic materials, such as those that
support magnetic charging or MagSafe.
• Single wireless charger cannot charge two
or more devices simultaneously.
&RPIRUW(TXLSPHQWV
119
6
https://www.automotive-manuals.net
To Next Page
Loading...
Need help?
General
