turning lamp are turned on, the daytime running
lamp will go off.
+LJK%HDP
– After the low beam is on, move the
combination switch forward once, and the high
beam is on. Move the combination switch
forward again, and the high beam goes off;
– Continuously move the combination switch
backwards and release it, and the high beam
will flash to remind the preceding vehicle.
FDXWLRQ
High beam will cause glare to oncoming
drivers. Please use high beam reasonably.
+HDGOLJKW+HLJKW$GMXVWPHQW
Tap “ →/LJKWV” in turn on the CID, to set the
height of the headlights.
3URSHU'ULYLQJ
218
9
https://www.automotive-manuals.net
To Next Page
Loading...
