• Disable: When the vehicle is stationary, press
the brake pedal, disable“(OHFWURQLF3DUNLQJ
%UDNH”or switch to the drive gear (D or R). The
indicator on the ICM is off, indicating that
the parking brake has been disabled. When
the vehicle is at P gear, it is unable to disable
parking brake by disabling “(OHFWURQLF3DUNLQJ
%UDNH”.
7LSV
• When enabling or disabling the electronic
parking brake, it is normal that the system
has operating noise.
• When enabling the electronic parking brake,
if the vehicle cannot be powered on and
the parking brake cannot be disabled due
to low voltage of 12V battery, disable it by
jump power connection or contact XPENG
Service Center for treatment.
• In special case, press and hold P gear
button to enable emergency braking
function EPB. The EPB light will flash in
emergency brake.
FDXWLRQ
• If the parking brake cannot be enabled
or disabled normally, immediately contact
XPENG Service Center for inspection and
repair.
• Do not drive the vehicle with parking brake
enabled, otherwise the electronic parking
brake system will be easily damaged.
$872+2/'
(QDEOHDQG'LVDEOH$XWR+ROG
If you need to stop for a while, deeply press
brake pedal after the vehicle stops. The indicator
on the ICM is on, indicating that auto hold
function has been activated. At this time, release
the brake pedal, and the system will
automatically apply the brake and keep the
vehicle stationary. After pressing the accelerator
pedal, the system automatically releases and
starts driving.
3URSHU'ULYLQJ
227
9
https://www.automotive-manuals.net