6. a. Turn on the power switch of the inflatable
pump and start injecting sealant into the
tire.
b. During the process of sealant injection,
the value of the pressure gauge is
approximately 300~600kPa.
c. Observe the pressure gauge until the tire
pressure reaches the standard value, then
turn off the power switch.
d. Reference to the Tire Pressure Label for
the standard tire pressure value for the tire
specification.
e. Check the tire pressure, if it cannot reach
the set value within 20 minutes, it will be
deemed as unable to repair the tire.
7. Turn off the inflatable pump, and then pull
out the sealant injection tube from the tire
valve. Wipe off the excess sealant from the tire
valve and the wheel hubs. Pull out the sealant
injection tube from the inflatable pump, and
put the emergency tire-repair kit back to the
trunk.
8. Drive the vehicle immediately for 5 km or 10
min at a speed between 20~60km/h to allow
the sealant spreading evenly throughout the
entire tire.
9. Stop the vehicle and check the tire pressure.
FDXWLRQ
If the tire pressure is below 130 kPa, it
indicates that the tire damage cannot be
repaired using the sealant. Park the vehicle
(PHUJHQF\$LG
284
12
https://www.automotive-manuals.net
To Next Page
Loading...
Need help?
General
