£CA
1
3300
NOTICE
------------
Make
sure
the
0-rlng
" 3"
Is
posit
ioned cor-
rectly In
the
groove
of
the oll filter cartridge.
3
c. Tighten the new oil filter cartridge to spe
ci
fi-
cation with an oil filter wrench.
Oil filter cartridge
17 Nm (1.7 m·kgf, 12
ft
·lbf)
••••••••••••••••••••••••••••••••
6. Install:
• Eng
in
e oil drain bolt
(along with the gasket
1emw
l
Engine
oil
drain
bolt
43 Nm (4.3 m-
k,gf,
31
ft
·lbf)
7. Fi
ll:
•Cr
ankcase
(with the specified amount of the recom-
mended engine o
il)
·'D>
Engine
oil
quanti
ty
Quantity (disassembled)
8. Install:
3.40 L (3.59 US
qt
, 2.99
Imp
.qt)
Without
oil filter cartridge re-
placement
2.40 L (2.54 US
qt
,
2.
11
Imp
.qt)
With oil filter cartridge replace-
ment
2.70 L (2.85 US
qt
, 2.38
Imp
.qt)
• Engine oil filler cap
(along with the 0 -
rin
g
IH£11
)
9. Start the engine, warm it up for several min-
utes, and then turn it off.
10.Chec
k:
• Eng
in
e
(for engine oil leaks)
11.Check:
• Eng
in
e oil level
Refer to "CHECKING THE ENGINE OIL
PERIODIC MAINTENANCE
LE
VEL" on page 3-22.
"""""'
MEASURING THE ENGINE OIL PRESSURE
1.
Check:
•
Eng
ine o
il
level
Below the minimum level ma
rk
"a"
--+
Add the
recommended engine oil to the proper leve
l.
2. Start the engine, warm it up f
or
several min-
ut
es,
and then tum it off.
ECA1
3'10
NOTICE
When the engine
is
cold
, the engine oil
will
have a higher
viscosity
, causing
the
engine
oil pressure
to
increase. Therefore,
be
sure
to
measure t
he
engine
oil
pressure
after
warming
up
the engine.
3. Remove:
• Main gallery bolt "1"
ew
...
1
MO
A wARNING
The engine, muffler and engine
oll
are
ex-
tremely hot.
4. Install:
• Oil pressure gauge "1"
3-24
• Adapter "2"
Pressure gauge
90890-03153
YU-03153
Oil pressure adapter H
90890-03139
To Next Page
