Yamaha FZ09E - Checking the Relief Valve; Assembling the Oil Pump; Installing Th Eoil Pump

EAS;.24971
CHECKING THE RELIEF VALVE
1. Ch ec k:
• Re lief va lve "1"
• Spring
"2"
Damage/wear ~ Replace the oil pump as -
sembl
y.
EAS2S(ll0
ASSEMBLING THE OIL PUMP
1. Lubric at e:
• Inner rotor
• Outer r
ot or
• Oil pump shaft
(with the recommended lubricant)
Recommended lubricant
r--· Engine oil
2. Install:
• Outer
ro tor "1"
• Inner rot or "2"
• Pin ''3"
• O il pump cover "4"
• O il pump cover screw
011 pump cover screw
3.8 Nm (0.38 m·kgf, 2.8 ft·lbf)
TIP ---------------
Align the pin "3" in the oil pump shaft wi th the
groove in
th e in ner rot or "2".
OIL PUMP
3. Check:
• Oil pu
mp operation
Refer to "CHECKING THE OIL
PUMP" on
page
5-52.
""""""
INSTALLING THE OIL PUMP
1. Insta ll :
• Oil pump
"1"
• Oil pu mp bolts "2"
Oil pump bolt
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
• Oil pu mp driven sprocket "3"
ECA1ACl508
NOTICE
011 pump driven sprocket bolt
15 Nm (1.5 m-kgf, 11 ft · lbf )
LOCTITE®
After installing the oil pump drive chain and
driven sprocket , make sure the oil pump
turns smoothly .
TIP
---------------
• 1 RC mar k of the oil pu mp d ri ven sprocket is in-
stalled
at oil pump side.
• Insta
ll the oil pu mp dr ive chain onto the oil
pu
mp driven sprocket.
1 . \
5-53