9. Check the gear position
sensor
Refer to "CHECKING THE GEAR
POSITION SENSOR" on page
8-11 o.
OK
t
1 o.Check the sidestand switch.
Refer to "CHECKING THE
SWITCHES" on page 8-89.
OK
t
11.Check the relay
un
it (diode).
Refer to
"C
HECKING THE RELAY
UN
IT (DIODE)" on page 8-99.
OK
t
12.Check the lean a
ng
le
sensor.
Refer to "CHECKING THE LEAN
ANGLE SENSOR" on page 8-101.
13.Check the entire
ig
nition system's
wiring.
Refer to "CIRCUIT DIAGRAM" on
page 8-1.
Replace the ECU.
Refer to "REPLACING THE ECU (en-
gine control unit)" on
page
8-93.
NG~
NG~
NG~
NG~
NG~
8-5
IGNITION SYSTEM
Replace the gear position sensor.
Replace the sidestand
sw
itch.
Replace the relay uni
t.
Replace the lean angle sensor.
Properly
co
nnect
or
repair the i
gn
iti
on
sys-
tem's wiring.
To Next Page
Loading...
