9. Check the gear position
sensor
Refer to "CHECKING THE GEAR
POSITION SENSOR" on page
8-11
o.
OK
t
1 o.Check the sidestand switch.
Refer to "CHECKING
THE
SWITCHES" on page 8-89.
OK
t
11.Check the clutch switch.
Refer to
"C
HECKING THE
SWITCHES" on page 8-89.
OK
t
12.Check the start/engine st
op
switch.
Refer to "CHECKING
THE
SWITCHES" on page 8-89.
13.Check the entire starting system's
wiring.
Refer to "CIRCUIT DIAGRAM" on
page 8-7.
The starting system circuit is OK.
ELECTRIC STARTING SYSTEM
NG-t
NG
-t
NG-t
NG-t
NG-t
8-12
Replace the
gear
position sensor.
Replace the sidestand
sw
itch.
Replace the clutch switch.
Replace the right handl
ebar
switch.
Properly connect or repair the starting sys-
tem's wiring.
To Next Page
Loading...
