Yamaha SEQTRAK - Song Mode; Switching to Song Mode; Switching to scene mode [Ver. 1.1]

SEQTRAK User Guide
70
12. Song Mode
This is an auto performance mode in which the patterns in the project are played in a pre-
determined order. Each project has one song, and a song consists of up to 16 scenes
(phrases that are a combination of patterns from all tracks).
In Ver. 1.1, a scene mode has been added. In scene mode, a single scene can be constantly
played back in a loop while switching scenes at any given time.
12.1 Switching to Song Mode
Hold down the [ALL] knob and press the [PROJECT↑] button to switch to Song mode. If a
project is being played back, switching to Song mode will stop playback.
When you switch to Song mode, [SONG] lights up on the index. To exit Song mode, first
switch to scene mode and then use the same procedure.
12.1.1 Switching to scene mode [Ver. 1.1]
When in Song mode, Hold down the [ALL] knob and press the [PROJECT↑] button to switch
to scene mode. Use the same procedure to exit scene mode.
NOTE
・ Exiting song or scene mode does not stop playback. Pattern combinations and
mute/solo status are maintained when you exit Song mode and scene mode.