SEQTRAK User Guide
17.6.2 DELAY
PARAMETER 2 PARAMETER 3
1
TEMPO DELAY 4TH
DELAY TIME
FEEDBACK LEVEL
FEEDBACK -
2
PING PONG DELAY 4TH
TEMPO CROSS -
DELAY TIME L>R &
FEEDBACK -
3
TEMPO DELAY 8TH DOT
DELAY TIME
FEEDBACK -
4
TEMPO DELAY 8TH
TEMPO DELAY -
DELAY TIME
FEEDBACK -
5
PING PONG DELAY 8TH
DELAY TIME L>R &
DELAY TIME R>L
FEEDBACK -
6
TEMPO DELAY 16TH
TEMPO DELAY -
DELAY TIME
FEEDBACK -
7
DELAY TIME
8
ANALOG DELAY RETRO
ANALOG DELAY -
DELAY TIME
DELAY INPUT –
17.7 Description of Sound Parameters
Parameter Description
SOUND SELECT Selects the type of sound.
PITCH Sets pitches by half-step intervals.
PAN Adjusts the left/right stereo image.
VOLUME Adjusts the volume.
AEG ATTACK
Sets the time from when a keyboard key is played until the volume
reaches the level set by the attack level.
AEG DECAY/RELEASE
DECAY: Sets the time from when the volume set at the attac
reached until the volume set at the decay level is reached.
RELEASE: Sets the time from when the keyboard key is released
until the note fades out.
LP-HP FILTER CUTOFF Sets the cutoff frequencies for the low-pass and high-pass filters.
LP-HP FILTER RESONANCE Applies resonance to the low-pass and high-pass filters.
REVERB SEND
Sets the amount of signal sent to the reverb effect (send level).
The larger the value, the deeper the reverb.
DELAY SEND
Sets the amount of signal sent to the delay effect (send level).
The larger the value, the stronger the delay.
EQ HIGH GAIN
Sets the amount of gain for increasing or decreasing the high
frequency range with the EQ.
EQ LOW GAIN
Sets the amount of gain for increasing or decreasing the low
frequency range with the EQ.
MONO/POLY/CHORD
Selects the voicing method.
MONO: single tone, POLY: multiple tones, CHORD: chords