YASKAWA MP3000 Series - Tuning; Using Sigmawin+ (When Using a Servo); Using Drivewizard Plus (When Using an Inverter)

5.4 Tuning
5.4.1 Using SigmaWin+ (When Using a Servo)
5-70
5.4 Tuning
This section describes how to perform tuning for the machine that is connected to the Machine
Controller.
5.4.1 Using SigmaWin+ (When Using a Servo)
The Servo can be tuned by connecting it to the SigmaWin+ via the Controller.
Refer to the following manual for details.
SigmaWin+ Online Manual (Manual No.: SIEP S800000 67)
5.4.2 Using DriveWizard Plus (When Using an Inverter)
The Inverter can be tuned by connecting it to the DriveWizard Plus via the Controller.
Refer to the following manual for details.
DriveWizard Plus Online Manual (Manual No.: TOEP C730600 20)