5.12 U: Monitor Parameters
YASKAWA ELECTRIC SIEP C710606 44B YASKAWA AC Drive T1000V Technical Manual 231
◆ U6: Control Monitors
Control monitors show:
• Reference data for the output voltage and vector control.
• ASR monitors. Refer to C5: Automatic Speed Regulator (ASR) on page 138 for details and an illustration that shows
where in the ASR block the monitors are located.
• The offset value added to the frequency reference by the Frequency Offset function. Refer to Setting 44/45/46: Offset
Frequency 1/2/3 Addition on page 166.
Refer to U6: Operation Status Monitors on page 363 for a complete list of U6- monitors and descriptions.
Note: Fixed monitors U6-80 to U6-99 for comm. options
Monitor content will vary based on the communication option card connected to the drive. For more information, refer to the
instruction manual included with the option card or to the Technical Manual.
◆ U9: KEB Voltage Monitors
These parameters allow the user to monitor the voltage levels used for KEB function start and end. For more information
on the U9 monitor parameter monitors, see U9: KEB Voltage Monitors on page 363.
To Next Page
Loading...
