52 YASKAWA ELECTRIC SIEP C710606 44B YASKAWA AC Drive T1000V Technical Manual
3.5 Protective Covers
3.5 Protective Covers
Follow the procedure below to remove the protective covers before wiring the drive and to reattach the covers after
wiring is complete.
◆ Removing the Protective Covers
1. Loosen the screw that locks the front cover in place to remove.
Figure 3. 6
Figure 3.6 Remove the Front Cover
2. Apply pressure to the tabs on each side of the terminal cover. Pull the terminal cover away from the drive while
pushing in on the tabs to pull the cover free.
Figure 3. 7
Figure 3.7 Remove the Terminal Cover
■ Reattaching the Protective Covers
Properly connect all wiring and route power wiring away from control signal wiring. Reattach all protective covers when
wiring is complete. Apply only a small amount of pressure to lock the cover back into place.
Figure 3. 8
Figure 3.8 Reattach the Protective Covers
To Next Page
Loading...
