YASKAWA T1000V - Digital Text Display

4.2 Using the Digital LED Operator
YASKAWA ELECTRIC SIEP C710606 44B YASKAWA AC Drive T1000V Technical Manual 75
Start-Up Programming & Operation
4
◆ Digital Text Display
Text appears on the LED Operator as shown below. This section explains the meaning of text as it appears on the display
screen.
Table 4.2 Digital Text Display
9 LO/RE Selection Key
Switches drive control between the operator (LOCAL) and the control circuit
terminals (REMOTE).
Note: LOCAL/REMOTE key effective during stop in drive mode. If the digital
operator could change from REMOTE to LOCAL by incorrect operation, set o2-01
(LOCAL/REMOTE Key Function Selection) to “0” (disabled) to disable LOCAL/
REMOTE key.
10 RUN Light Lit while the drive is operating the motor.
11 LO/RE Light Lit while the operator (LOCAL) is selected to run the drive.
12 ALM LED Light
Refer to LED Screen Displays on page 76.
13 REV LED Light
14 DRV LED Light
15 FOUT LED Light
Lit Flashing
Text LED Text LED Text LED Text LED
09IR
1AJ S
2BKT
3CLU
4DM
<1>
V
5ENW
<1>
<1> Displayed in two digits.
6 F O X none
7GPY
8 H Q Z none
No. Display Name Function