YASKAWA T1000V - 4.3 The Drive and Programming Modes

78 YASKAWA ELECTRIC SIEP C710606 44B YASKAWA AC Drive T1000V Technical Manual
4.3 The Drive and Programming Modes
4.3 The Drive and Programming Modes
The drive functions are divided into two main groups accessible via the Digital LED Operator:
Drive Mode: The Drive mode allows motor operation and parameter monitoring. Parameter settings cannot be changed
when accessing functions in the Drive Mode (Table 4.3).
Programming Mode: The Programming Mode allows access to setup/adjust, verify parameters and Auto-Tuning. The
drive prohibits changes in motor operation such as start/stop when the Digital LED Operator is accessing a function in
the Programming Mode.
Table 4.3 illustrates the different functions visible as the “Up arrow” is scrolled immediately after powering up the drive.
Note: When b1-08 (Run Command Selection while in Programming Mode) is set to 1 (enabled), the drive can run even if the mode is
switched to the programming mode. When setting b1-08 to 0 (disabled), the mode cannot be switched to the programming mode
while the drive is running.
Table 4.3 Summary of Modes
Mode Group Description Key Press LED Digital Operator Display
Drive Mode Functions
(Motor operation and monitoring)
Frequency Reference Display (Initial
power-up state)
Forward/Reverse
Output Frequency Display
Output Current Display
Output Voltage Reference
Monitor Display
Programming Mode Functions
(Changing parameters)
Verify Function
Set up Mode (Setup Group Parameters)
Parameter Setting Mode (All
Parameters)
Auto-Tuning