Yealink SIP-T48G - Page 100

Administrator’s Guide for SIP-T2 Series/T19(P) E2/T4 Series/CP860 IP Phones
80
?p=network&q=load
Phone User Interface
Configure PPPoE on the IP phone.
Configure the user name and
password for PPPoE on the IP
phone.
Details of Configuration Parameters:
Parameters
Permitted Values
Default
network.internet_port.type
0, 1 or 2
0
Description:
Configures the Internet (WAN) port type for IPv4.
0-DHCP
1-PPPoE (not applicable to SIP-T42G/T41P/CP860 IP phones)
2-Static IP Address
Note: It works only if the value of the parameter “network.ip_address_mode” is set to
0 (IPv4) or 2 (IPv4 & IPv6). If you change this parameter, the IP phone will reboot to
make the change take effect.
Web User Interface:
Network->Basic->IPv4 Config
Phone User Interface:
Menu->Settings->Advanced Settings (default password: admin) ->Network->WAN
Port->IPv4
network.pppoe.user
String within 32
characters
Blank
Description:
Configures the user name for PPPoE connection.
Example:
network.pppoe.user = Xmyl0592123
Note: It works only if the value of the parameter “network.ip_address_mode” is set to
0 (IPv4) or 2 (IPv4 & IPv6), and "network.internet_port.type" is set to 1 (PPPoE). If you
change this parameter, the IP phone will reboot to make the change take effect. It is
not applicable to SIP-T42G, SIP-T41P and CP860 IP phones.
Web User Interface:
Network->Basic->IPv4 Config->PPPoE->User Name
Phone User Interface:
Menu->Settings->Advanced Settings (default password: admin) ->Network->WAN