Yealink SIP-T48G

Configuring Basic Features
145
Parameters
Permitted Values
Default
Description:
Enables or disables the user to access web user interface of the IP phone using the
HTTPS protocol.
0-Disabled
1-Enabled
Note: If you change this parameter, the IP phone will reboot to make the change take
effect.
Web User Interface:
Network->Advanced->Web Server->HTTPS
Phone User Interface:
Menu->Settings->Advanced Settings (default password: admin)
->Network->Webserver Type->HTTPS Status
network.port.https
Integer from 1 to 65535
443
Description:
Configures the HTTPS port for the user to access web user interface of the IP phone
using the HTTPS protocol.
Note: If you change this parameter, the IP phone will reboot to make the change take
effect.
Web User Interface:
Network->Advanced->Web Server->HTTPS Port(1~65535)
Phone User Interface:
Menu->Settings->Advanced Settings (default password: admin)
->Network->Webserver Type->HTTPS Port
To configure web server type via web user interface:
1. Click on Network->Advanced.
2. Select the desired value from the pull-down list of HTTP.
3. Enter the desired HTTP port number in the HTTP Port(1~65535) field.
The default HTTP port number is 80.
4. Select the desired value from the pull-down list of HTTPS.
5. Enter the desired HTTPS port number in the HTTPS Port(1~65535) field.