Yealink SIP-T48G

Administrator’s Guide for SIP-T2 Series/T19(P) E2/T4 Series/CP860 IP Phones
440
Parameters
Permitted Values
Default
If the phone receives an incoming call from the phone number 0044123456789, it will
search 0044123456789 from the LDAP sever first, if no result found, it will search
+44123456789 from the server again. The phone will display all the search results.
Note: It works only if the value of the parameter “ldap.call_in_lookup” is set to 1
(Enabled). You may need to set the value of the parameter “ldap.name_filter” to be
(|(cn=%)(sn=%)(telephoneNumber=%)(mobile=%)) for searching the telephone
numbers starting with ”+” symbol. It is not applicable to SIP-T19(P) E2 IP phones.
Web User Interface:
None
Phone User Interface:
None
LDAP Key
For more information on how to configure the DSS Key, refer to Appendix D: Configuring
DSS Key on page 796.
Details of Configuration Parameters:
Parameters
Permitted Values
Default
linekey.X.type/
programablekey.X.type/
expansion_module.X.key.Y.type
38
Refer to the
following content
Description:
Configures a DSS key as an LDAP key on the IP phone.
The digit 38 stands for the key type LDAP.
For line keys:
X ranges from 1 to 29 (for SIP-T48G)
X ranges from 1 to 27 (for SIP-T46G/T29G)
X ranges from 1 to 15 (for SIP-T42G/T41P)
X ranges from 1 to 21 (for SIP-T27P)
X ranges from 1 to 3 (for SIP-T40P/T23P/T23G)
X ranges from 1 to 2 (for SIP-T21(P) E2)
For programable keys:
X=1-10, 12-14 (for SIP-T48G/T46G)
X=1-10, 13 (for SIP-T42G/T41P/T40P)
X=1-14 (for SIP-T29G/T27P)