Administrator’s Guide for SIP-T2 Series/T19(P) E2/T4 Series/CP860 IP Phones
558
AlwaysFwdOn/BusyFwdOn/NoAns
wFwdOn=xxx=n
Activate an always/busy/no answer
forward feature to xxx for the IP phone
(“xxx” means the destination number)
The valid value of “n” means the duration
time (seconds) before forwarding incoming
calls (n is the times of 6, e.g., 24). It is only
applicable to no answer forward feature.
Note: It works only if the call forward mode
is Phone, the always/busy/no answer
forward feature will apply to all the
accounts on the phone.
Example:
http://10.10.20.10/servlet?key=NoAnswFwd
On=1001=24
AlwaysFwdOff/BusyFwdOff/NoAns
wFwdOff
Deactive the always/busy/no answer
forward feature for the IP phone.
Note: It works only if the call forward mode
is Phone, the always/busy/no answer
forward feature will apply to all the
accounts on the phone.
Example:
http://10.10.20.10/servlet?key=NoAnswFwd
Off
ASW/CANCEL/HOLD/UNHOLD:xxx
Answer/end/hold/unhold a call (xxx refers
to the call-id of the active call).
Example:
http://10.10.20.10/servlet?key=ASW:33093
Note: To get the call-id of the active call,
configure the action URL:
http://phone IP
address/help.xml?CallId=$call_id
. For
more information, refer to Action URL on
page 534.