Yealink SIP-T48G

Administrator’s Guide for SIP-T2 Series/T19(P) E2/T4 Series/CP860 IP Phones
638
Parameters
Permitted Values
Default
Account->Advanced->Keep Alive Type
Phone User Interface:
None
account.X.nat.udp_update_time
Integer from 15 to
2147483647
30
Description:
Configures the keep-alive interval (in seconds) for account X.
X ranges from 1 to 16 (for SIP-T48G/T46G/T29G)
X ranges from 1 to 12 (for SIP-T42G)
X ranges from 1 to 6 (for SIP-T41P/T27P)
X ranges from 1 to 3 (for SIP-T40P/T23P/T23G)
X ranges from 1 to 2 (for SIP-T21(P) E2)
X is equal to 1 (for SIP-T19(P) E2/CP860)
Example:
account.1.nat.udp_update_time = 60
Note: It works only if the value of the parameter “account.X.nat.udp_update_enable” is
set to 1, 2 or 3.
Web User Interface:
Account->Advanced->Keep Alive Interval(Seconds)
Phone User Interface:
None
To configure the type of keep-alive packets and keep-alive interval via web user
interface:
1. Click on Account->Advanced.
2. Select the desired account from the pull-down list of Account.
3. Select the desired value from the pull-down list of Keep Alive Type.
4. Enter the keep-alive interval in the Keep Alive Interval(Seconds) field.