Yealink SIP-T48G

Configuring Advanced Features
653
Parameters
Permitted Values
Default
->Network->WAN Port->IPv6->Static IPv6 Client->IPv6 Pri.DNS
Or Menu->Settings->Advanced Settings (default password: admin)
->Network->WAN Port->IPv6->DHCP IPv6 Client->Staic DNS(Enabled) ->IPv6
Pri.DNS
network.ipv6_secondary_dns
IPv6 address
Blank
Description:
Configures the secondary IPv6 DNS server.
Example:
network.ipv6_secondary_dns = 2026:1234:1:1:c3c7:c11c:5447:23a6
Note: It works only if the value of the parameter "network.ip_address_mode" is set
to 1 (IPv6) or 2 (IPv4 & IPv6). In DHCP environment, you also need to make sure the
value of the parameter "network.ipv6_static_dns_enable" is set to 1 (On). If you
change this parameter, the IP phone will reboot to make the change take effect.
Web User Interface:
Network->Basic->IPv6 Config->Static IP Address->Secondary DNS
Phone User Interface:
Menu->Settings->Advanced Settings (default password: admin)
->Network->WAN Port->IPv6->Static IPv6 Client->IPv6 Sec.DNS
Or Menu->Settings->Advanced Settings (default password: admin)
->Network->WAN Port->IPv6->DHCP IPv6 Client->Staic DNS(Enabled) ->IPv6
Sec.DNS
network.ipv6_icmp_v6.enable
0 or 1
1
Description:
Enables or disables the IP phone to obtain IPv6 network settings via SLAAC
(Stateless Address Autoconfiguration) method.
0-Disabled
1-Enabled
Note: If you change this parameter, the IP phone will reboot to make the change
take effect. It is only applicable to SIP-T48G/T46G/T29G IP phones. SLAAC is enabled
on SIP-T42G/T41P/T40P/T27P/T23P/T23G/T21(P) E2/T19(P) E2/CP860 IP phones by
default. You are not allowed to configure this parameter for those IP phones.
Web User Interface:
Network->Advanced->ICMPv6 Status->Active
Phone User Interface: