EasyManua.ls Logo

YOKOGAWA ADMAG AXR - 9.7 Self-diagnostic Functions; 9.8 HART Specific Functions; 9.8.1 Test Output, Simulation, and Squawk

YOKOGAWA ADMAG AXR
200 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
<9. OPERATION VIA HART CONFIGURATION TOOL (HART 7)>
9-1
IM 01E30D01-01EN
9.
OPERATION VIA HART CONFIGURATION TOOL (HART 7)
ThisChapterdescribesthedevice(AXR)operation
proceduresusingaHARTcongurationTool(such
as FieldMate).
NOTE
For more details regarding the operations for
theHARTcongurationtool,readtheHART
congurationtooloperationsmanual.
Note: HART is a registered trademark of the
FieldComm Group.
9.1 HART Protocol Revision
For the models with the output signal code “-J”,
HART protocol revision 5 or 7 is selectable. The
protocolrevisionissetasspeciedintheorder.
Howtoconrmprotocolrevisionisshownbelow.
Therearetwowaystoconrmtheprotocolrevision
set to the transmitter.
(1)Conrmationbythenameplate
The HART protocol revision at the time of
shipment is shown by the last number at the
serial number column of the name plate.
F0901.ai
XXX…XX
5: HART 5
7: HART 7
(2) ConrmationbyusingHARTcongurationtool
Follow the procedure below.
1)Connectthecongurationtooltothedevice.
2) Call up “Review4” display.
[Root Menu]→Review→Review4
3) HART protocol revision is displayed on the
“Universal rev” column.
IMPORTANT
Protocol revision supported by HART
congurationtoolmustbethesameorhigher
than that of the device.
Protcol revision
supported by HART
congurationtool
5 7
Protocol revision of
the device
5
7 ×
 : Communication OK
×: Communication NG
NOTE
• InthisUser’sManual,HARTprotocol
revision 5 and 7 are described as HART 5
and HART 7 respectively.
• HART7communicationissupportedby
FieldMate R2.04 or later.
NOTE
When the output signal code of the device is “-J”,
HART protocol revision can be changed. Read
Subsection 9.8.5 about the procedure of the
revision change of HART 5 and HART 7.
9.2 Device Description (DD) on
aHARTCongurationTool
and AXR Device Revision
9.2.1 DD Revision and Device Revision
BeforeusingtheHARTCongurationTool(such
asFieldMate),conrmthattheDD(Device
Description)oftheAXRisinstalledinthe
CongurationToolbeforeusing.
• AXR:HART7
• Devicetype:0x3757
• DeviceRevision:10
• DDRevision:1
TheDDrevisionsforAXRandCongurationTool’s
canconrminaccordancewiththefollowingsteps.
If the correct DD is not installed in the HART

Table of Contents

Related product manuals