YOKOGAWA ADMAG AXR - Setting Mode

<5. BASIC OPERATING PROCEDURES (USING THE DISPLAY UNIT)>
5-4
IM 01E30D01-01EN
F0503-2.ai
Entry Mode
(*1)
The reversed-character (i.e. the cursor position)
indicates the item that is currently selected.
Setting Mode
To Parameter
Search Mode
ESC
SET
INC
DEC
/SHIFT
INC
SETESC INC
DEC /SHIFT
Setting mode
No
Yes
ESC
SET
SET
DEC
/SHIFT
INC
SETESC INC
DEC /SHIFT
Setting mode
No
Yes
ESC
SET
DEC
/SHIFT
INC
SETESC INC
DEC /SHIFT
Setting mode
▲ P:Protect
B:Easy Setup
▼ C:Basic Setup
ESC
SET
SET
DEC
/SHIFT
INC
SETESC INC
DEC /SHIFT
Setting mode
Yess
Ascreenisdisplayedtoconrmwhetherornotthe
system is to enter Setting Mode.
Press the
INC
switch and select [Yes].
NOTE
(*1)
The Major Item Parameter which is set just
before will be shown when entrying the Setting
Mode again within 1 minute after returning from
Setting Mode to Display Mode.
When [Yes] has been selected, touch the
SET
switch.
NOTE
When no operations in this display are carried
out for 20 seconds, the system will automatically
return to the Display Mode.
When the operations except
SET
switch are
carried out, the system will automatically return
to the Display Mode.
Inordertorequestconrmation,theentiredisplay
ashesonandoff.
Touch the
SET
switch once again at this time to
xyourselection.
NOTE
Whennooperationsintheasheddisplay
are carried out for 20 seconds, the system will
automatically return to the Display Mode.
When the operations except
SET
are carried
out, the system will automatically return to the
Display Mode.
The system enters Setting Mode.
Parameters to be set can be selected.
This completes the procedure for changing from the
Display Mode to the Parameter Search Mode.